Portable CO2 Gas Shielded Corner Welding Carriage HUAWEI HK-6A

Description

The HUAWEI HK-6A portable corner welding carriage is a co2 shielded auto-welding trolley. It consists of the car body,  control wire, fitting parts, fuse, hex-angular screw and other components. This MIG welding carriage is with small volume, light weight and stable welding, which is easy for movements and installation, and can deliver vertical angle welding and horizontal angle welding, and suitable for welding of cross section of reinforcing stimulus.

This welding trolley can be used with semiautomatic（CO2/MAG）welding machine(power and feeder).

（ Illustration：The only signal is welding torch switch signal, which make the trolley

connected to welding machine. Because the signal, which the trolley supply to welding machine, is  normal  open  signal  and there  must  be  stump  in welding  process.  So you  must  make the retracting arc switch be on“No Self-Holding position.

The model number of plug of signal wire is E”-25-2P. (It can connect feeders of

Panasonic company or Osaka Company. If connect other feeder device, you may modify a little. You must make  （1）welding conducting wire,  （2）gas hosepipe,  （3）torch

connected to feeder device. According to brand of power, the plug may be different.

Specifications:

Working Panel:

1）  Power indicated lamp: When the power is on, the lamp is light.[/caption]

2） Speed  control  knob:  Increase  speed  when  you  revolve  clockwise,  decrease  speed  when revolve anti-clockwise.

Speed  scale  matches  following  speed  chart:  Adjust  the  welding  speed  according  to  welding specifications.

3）  Stop  button：Press  down the  button  and the trolley stop walking. The selector switch can control whether the welding stops.

4)    Walking guide and power switch: The switch is used to control welding guide and power.

5)     Start button：Press down the button and the trolley begin to walk. The selector switch can control whether welding begins at the same time.

6)     Model select switch—there are three positions. The individual function is :

TEST：On this  position, the feeder works. You  can  control  arc starting/  retracting  arc  by  your hands, then reset after release.

ARC ON：On this position, the normal welding begins. If you press down firing switch, the trolley starts to walk at the time of arc starting.

NEUT：On this position, if you press down start button, the trolley walks but the welding doesn’t start.